DENSO BTG-2 Belt Tension Gauge
Specialty
One1 Belt tension can be correct, and simple determination
One2 Using an extension rod (optional), can also be tested in a small place.
One3 The use of the method of measuring the needle, the most suitable for the determination of the area covered by the belt.
2.Usage method
Two point oneEach department name
A.The main part ofB. pressure C. extension rod (optional)
OneConnecting part 7 handle 10Interface
TwoReturn 0Button 8 steering wheel 11 outer shaft
ThreePointer 9 interface nut 12Interface nut
FourDial 13 inner shaft
Fivehook
SixThe shelf
Two point twoOperational attention
OneThis is the belt tension measuring device, when not in use, please put in the bag for safekeeping.
2Instruments should not be dropped, hit, do not twist the hook, the curve can not be a normal slide, you can not correctly test.
ThreeThe belt tension were lower (About100NPlease do not test, because it is possible to cause a pointer to the twisted and internal gear damage.
FourResin material of the shell do not touch the mineral lines, oil, oil, if you hit, immediately wipe clean, so as not to determine the normal.
FiveInside the instrument, please do not just go to the spin off, adjust.
SixRegular use of gauge accuracy test (optional).
Two point threeOperation method
OneReturn to the “0” operation
The numerical representation is the belt tension with the pointer, so the determination will return a pointer to “0” position.
This operation is the return of the 0 button.Central projection small button) to the direction of the arrow, dial pointer to dial 0Location (red part range)
Twomeasureset
1)Hold the tensiometer steering handle and disc is the dynamometer test essentials, as FigureThreeshows, the hook on the belt to be measured.