HEIDON Friction Tester Meter Muse TYPE : 37i
Vacuum Friction and Wear Tester Tribovac2000 Incorporation in a Vacuum Tank of Various Types of Friction and Wear Testing Equipment for Testing in a Vacuum By incorporating highly reputed Tribogear friction and wear testers in a vacuum chamber, it has Read More …
Surface quality measuring machine TYPE: 38 Birth of a high-performance, low-cost friction and wear tester. We have reduced costs as much as possible while maintaining the measurement performance of friction gears. The basic performance is comparable to high-end models such Read More …
Low Load Wear Tester TYPE:36 Tribogear with a Minimum 0.1g-10g Loading Range This is a wear tester that allows measurement from very low loading (0.1g) that was previously difficult to measure, to a maximum loading of 10g. A turntable with Read More …
Wide-Range Load Friction and Wear Tester TYPE:35 Super Wide Range! Allowing Testing from Minimum 20g to Maximum 100kg Using a high sensitivity balance arm method for the minimum loading of 20g up to 10kg, high loading from 10kg to 100kg Read More …
Rotating Drum/Both-way Sliding Combined Friction and Wear Tester TYPE:34 Two Types of Testing in One Instrument! Both-way Sliding Testing and Rotating Drum Testing This friction and wear tester allows not only the same sliding testing as that offered by TriboStation, Read More …
Adhesion and Peeling Resistance Tester TYPE:17 Use for Peeling and Tensile Strength Evaluations The test piece clamps on both sides move at the same speed in opposite directions, and the resistance is accurately measured at one of the clamps. An Read More …
Static Friction Coefficient Tester TYPE:10 Easy Static Friction Coefficient Measurement Allows Use as a Research, Inspection and Teaching Aid The test piece is installed on the ascending board and flat indenter. The ascending board is provided with a sensor that Read More …
Continuous Loading Scratching Intensity Tester TYPE:18/18L Indicates Scratch Resistance in Numerical Values using Continuous Loading onical scratch needles are used, which have R-processed tips (various types between 0.005-1.0mm). As the mobile base loaded with the test piece travels, continuous loading Read More …
TYPE:22 Evaluates Film Adhesion from the Scratch Resistance caused by Continuous Loading Using two pulse motors, the mobile base that is loaded with the test piece and the continuous loading weight guide are moved simultaneously. In order to rotate the Read More …
Torque Type Friction and Wear Tester TYPE:20 Disk-on-disk and Ball-on-disk Friction and Wear Testing The torque converter is directly connected to the turntable on which the test piece can be mounted. For the loading, it will be possible to select Read More …